On the '15-'16 glove boxes, the hinge wire is bent as it crosses the door, kind of a lazy Z shape, with one end of the Z much longer than the other (the outside end), what is this for, and how does one remove or install the door? Bend the wire?? Was the door spring loaded at all to stay in the closed postition, or was it only held there by the latch. And now about the latch--I have two dashes, and neither one has the latch mechanism, just the hole in the door with two rivet holes on either side--actually one door does still have the metal plate against the door from the latch, but nothing else. What am I looking for?? Many thanks!! Oh, my '16 Speedo remains are different from any others I've seen--the hole in the dash for it has a 'cone' shaped cutout where the trip wheel is, and the front plate covers this, with the wheel somewhat recessed (the cover has a recessed slot for the wheel). Also, the speedometer cable mount comes out that side of the speedometer with a 90 degree end for the cable (the cable opening points straight down. Since my speedo is badly damaged & missing most of the parts, I am planing on making a trim ring for a replacement speedo (the normal dial one with the cable straight out the bottom) to cover this hole (it's a factory hole so I don't want to change it). I figure that way, if I ever find the right speedo, I can just change them out. Any ideas?
|