View topic - Rebuilding ignigition switch

dodgebrothersclub.org
http://www.dodgebrothersclub.org/phpbbforum/

Rebuilding ignigition switch
http://www.dodgebrothersclub.org/phpbbforum/viewtopic.php?f=3&t=379
Page 1 of 1

Author:  OdellOvergaard [ Sun Jun 19, 2016 10:33 am ]
Post subject:  Rebuilding ignigition switch

Does any one out there have a good way to rebuild the fiber on early DB ignition switch or know of any one offering a replacement for it?

Author:  Guest [ Sun Jun 19, 2016 2:25 pm ]
Post subject:  Re: Rebuilding ignigition switch

OdellOvergaard wrote:
Does any one out there have a good way to rebuild the fiber on early DB ignition switch or know of any one offering a replacement for it?

What is the model. Is it a Clum switch?
I used a material I got from Restoration Supply. There is a link on this site.

Author:  OdellOvergaard [ Sun Jun 19, 2016 5:27 pm ]
Post subject:  Re: Rebuilding ignigition switch

It is a 1919 model 30. It has the Clum switch. Thinking about super glueing the layers and then clamping it together and see if that holds.

Odell

Author:  Guest [ Mon Jun 20, 2016 2:05 am ]
Post subject:  Re: Rebuilding ignigition switch

If you get the fiber pieces wet, you can then clamp them flat. Once they dry out, they will stay flat (for a while!) and you can then glue them together--but I would not use "super glue" but a very runny, non-electric epoxy, or Quik-Poly works very well too. You need it thin so it can soak into the fiber and provide a solid bond.

Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/