View unanswered posts | View active topics
|
Page 1 of 1
|
[ 4 posts ] |
|
Author |
Message |
josephsharp
|
Posted: Fri Nov 14, 2014 5:49 pm |
|
Joined: Fri Nov 14, 2014 4:58 pm Posts: 7
|
i need photos of a 23 screenside rear fender mounting points and overall views as i need both rear fenders for my truck. also i need to verify that i measured my wheels at 23 1/4 inch across and 2 3/4 rim width and have been told that i need 24" split rims and 32x4 tires and tubes if so i need used rims tires and tubes that size .Finally,my floor mounted starter switch button does not spring back and i see no spring between bottom side of button and switch,should there be or why is my button not springing back? thanks for any help sharpy 740 663-5010
|
|
Top |
|
|
DennisSchmidt
|
Posted: Sun Nov 16, 2014 1:54 am |
|
Joined: Sat Feb 11, 2012 5:19 am Posts: 12
|
In the 1921 Master Parts Book, there is a photo of a floor starter switch and from the looks of it the spring is on the inside. I know your Dodge is a year or two newer but I think the spring is on the inside. I hope this information helps. Good Luck Dennis Schmidt
|
|
Top |
|
|
josephsharp
|
Posted: Wed Dec 17, 2014 10:29 am |
|
Joined: Fri Nov 14, 2014 4:58 pm Posts: 7
|
Thanks,dennis, spring was inside and my bushing( wich i did not even realize was a bushing/collar ) was stuck in holding the spring down. this in turn burnt the relay inside.I have freed the bushing and replaced the relay and all is well .I still need 2 of the 24" split rims and 4 used tires and tubes 32x4 keep me in mind.Thanks,Sharpy
|
|
Top |
|
|
DavidYoung
|
Posted: Mon Sep 04, 2017 2:49 pm |
|
Joined: Thu Mar 21, 2013 7:06 pm Posts: 137
|
|
Top |
|
|
|
Page 1 of 1
|
[ 4 posts ] |
|
Who is online |
Users browsing this forum: No registered users and 100 guests |
|
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot post attachments in this forum
|